Rear

1. Remove coil spring as previously described.
2. Using screwdriver, open routing clamp and disengage parking brake cable from control arm.
3. Unfasten brake caliper and position aside, leaving brake line attached.
4. Remove stub shaft nut, then pull off wheel hub.
5. Working from under vehicle, pull wheel stub shaft out of control arm.
6. Remove control arm inner and outer attaching bolts and the control arm.
7. Reverse procedure to install, noting the following:
a. When installing control arm attaching bolts, ensure bolt heads face inboard. Use blue bolts and nuts for outboard side and gold bolts and nuts for inboard side.
b. With vehicle weight on tires, torque control arm attaching bolts to 63-74 ft. lbs.