Engine Mount: Service and Repair

Fig. 3 Engine Mounts. 1989-90:

Fig. 4 Engine Mounts. 1991-92:

LH INSULATOR & SUPPORT ASSEMBLY

1. Raise and support vehicle.
2. Remove left front tire and wheel assembly, then support transaxle using suitable jack and block of wood.
3. Remove insulator to support attaching nuts, Figs. 3 and 4.
4. Remove insulator to frame through bolts, then raise transaxle enough to unload insulator.
5. Remove support assembly to transaxle attaching bolts.
6. On 1989-90 models, remove insulator and/or support assembly.
7. On 1991-92 models, rotate support assembly counterclockwise to remove from upper stud.
8. On all models, reverse procedure to install.

RH FRONT NO. 2 & RH REAR NO. 3

1. On 1989-90 models, remove lower insulator bolt from righthand side of engine. Refer to ENGINE DAMPER.
2. On all models, raise and support vehicle.
3. Place jack and wood block under engine block.
4. Remove nuts retaining righthand front and righthand rear insulators to frame, Figs. 3 and 4.
5. Raise engine enough to unload insulator, then remove through bolts and engine mounts.
6. Reverse procedure to install.