Right Front

Removal

WARNING: THE ELECTRICAL CIRCUIT NECESSARY FOR SYSTEM DEPLOYMENT IS POWERED DIRECTLY FROM THE BATTERY AND BACKUP POWER SUPPLY. TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE BATTERY GROUND CABLE AND BACKUP POWER SUPPLY MUST BE DISCONNECTED PRIOR TO SERVICING OR REPLACING ANY SYSTEM COMPONENTS.

1. Disconnect battery ground cable and backup power supply.
2. Remove battery.
3. Disconnect RH front sensor electrical connector and wiring retainer.
4. Remove two screws retaining RH front sensor to RH fender apron and remove sensor.





Installation
1. Position RH front sensor and wire lead in vehicle and secure sensor to RH fender apron with retaining screws. Tighten screws to 4-5 Nm (35-44 lb-in).
2. Connect RH front sensor wire lead connector to wiring assembly connector and secure wiring retainer.
3. Install battery.
4. Connect backup power supply and battery ground cable.
5. Verify air bag indicator lamp.