Compressor

NOTE: Whenever a compressor is replaced, it will be necessary to replace the suction accumulator/drier.








Removal

1. Discharge system following recommended service procedures. Observe all safety precautions.

2. Disconnect compressor clutch wires at field coil connector on compressor.

3. Loosen drive belt.

4. Disconnect hose assemblies from condenser and suction line.

5. Remove four bolts.

6. Remove compressor and manifold and tube assembly from vehicle as a unit. Assembly will not clear sub-frame and radio support if attempt is made to remove unit from bottom. It must be removed from top.

7. Remove manifold and tube assembly as an onbench operation.

8. If compressor is to be replaced, remove clutch and field coil assembly.



Installation

1. New service replacement FS-6 compressor contains 300ml (10 fluid ounces) of specified refrigerant oil. Before replacement compressor installation drain 120ml (4 fluid ounces) of refrigerant oil from compressor. This will maintain total system oil charge within specified limits.

2. Install manifold and tube assembly on A/C compressor (two bolts).

3. Install compressor and manifold and tube assembly on A/C mounting bracket (four bolts).

4. Using new o-rings lubricated with clean refrigerant oil, connect suction line to compressor manifold and tube assembly. Attach discharge line to A/C condenser.

5. Connect clutch wires to field coil connector.

6. Install drive belt. Adjust drive belt tension to 190-217 Nm (140-160 lb-ft).

7. Leak test, evacuate and charge system following recommended service procedures. Observe all safety precautions.

8. Check system for proper operation.