Front Door Glass

1. Remove door trim panel and watershield. Doors

2. Lower door glass approximately 75mm (3 inches) from full-up position.

3. Loosen nut and washer assemblies (A) and (B) retaining the equalizer bracket to door inner panel.

4. Loosen nut and washer assembly (C) retaining door glass stabilizer.

5. With door open, place hands on each side of glass and pull glass fully into door glass run assembly at B-pillar.

6. Tighten nut and washer (A). Apply a downward pressure on the equalizer bracket and tighten nut and washer (B) to 7-11 N-m (5-8 lb-ft).

7. Set door glass stabilizer so that it is slightly touching glass and tighten nut and washer assembly to 7-11 N-m (5-8 lb-ft). If the "B" hole is a vertical slotted hole, make sure that the nut and washer (B) is positioned at the bottom of the slot as you apply a downward pressure on the equalizer bracket. Then tighten nut and washer (B) to 7-11 N-m (5-8 lb-ft).

8. Cycle door glass to ensure proper functioning and door fit.