Computers and Control Systems: Technical Service Bulletins

• Customer Interest
  • PCM - MIL ON/Code 41 Stored In Extreme Cold
  • Engine - Hard Cold Starts/Hesitation/Stalls On Start-Up
    • Overview
    • Procedures, Warranty and Labor
    • Idle Speed Adjustment
    • Procedure # 1
    • Procedure # 2 Idle Air By-Pass Valve Cleaning Only
    • Warranty Coverage
    • Labor Standards Operations
    • Operation Description
  • EEC IV Test Plug - Heat Damage
• By Symptom
  • Abnormal wear/deterioration
    • EEC IV Test Plug - Heat Damage
  • Customer Interest
    • PCM - MIL ON/Code 41 Stored In Extreme Cold
    • Engine - Hard Cold Starts/Hesitation/Stalls On Start-Up
      • Overview
      • Procedures, Warranty and Labor
      • Idle Speed Adjustment
      • Procedure # 1
      • Procedure # 2 Idle Air By-Pass Valve Cleaning Only
      • Warranty Coverage
      • Labor Standards Operations
      • Operation Description
    • EEC IV Test Plug - Heat Damage
  • Driveability
    • Engine - Hard Cold Starts/Hesitation/Stalls On Start-Up
      • Overview
      • Procedures, Warranty and Labor
      • Idle Speed Adjustment
      • Procedure # 1
      • Procedure # 2 Idle Air By-Pass Valve Cleaning Only
      • Warranty Coverage
      • Labor Standards Operations
      • Operation Description
  • False instrument warning light/gauges
    • PCM - MIL ON/Code 41 Stored In Extreme Cold
• All Technical Service Bulletins
  • Electrical/Electronic/Fuel Induction - Glossary
    • Overview
    • A
    • B
    • C
    • D
    • E
    • F
    • G
    • H
    • I
    • J
    • K
    • L
    • M
    • N
    • O
    • P
    • Q
    • R
    • S
    • T
    • U
    • V
    • W
    • X
    • Z
  • PCM - MIL ON/Code 41 Stored In Extreme Cold
  • Vehicle - Welding Precautions
  • IDM and Spark Timing Diagnosis - Manual Revision
  • EEC IV - Revised Pinpoint Test Steps
  • Electronic Modules - Protection From Static Electricity
  • EEC Connector - Color Code Changes
  • Engine - Hard Cold Starts/Hesitation/Stalls On Start-Up
    • Overview
    • Procedures, Warranty and Labor
    • Idle Speed Adjustment
    • Procedure # 1
    • Procedure # 2 Idle Air By-Pass Valve Cleaning Only
    • Warranty Coverage
    • Labor Standards Operations
    • Operation Description
  • Body/Frame - Arc Welding Precautions
  • EGO Sensors - Silicone Contamination
  • Speed Sensor Resistance Reading - Manual Revision
  • EEC IV Test Plug - Heat Damage