Window Regulator Motor

Removal






1. Raise window to full-up position, if possible. If glass cannot be raised and is in a partially down or full-down position, it must be supported so that it will not fall into door well during motor removal.
2. Disconnect battery ground cable.
3. Remove door trim panel and watershield. Doors. Disconnect window motor wiring leads.
4. Remove two forward regulator mounting plate attaching rivets.

CAUTION: Prior to motor drive assembly removal, ensure that the regulator arm Is In a fixed position to prevent dangerous counterbalance spring unwind.

5. Remove three window motor mounting screws.
6. Push regulator mounting plate outboard sufficiently to remove power window motor.

Installation

1. Position the motor and drive to the regulator and install the three screws snug-not tight.
2. Connect the motor wires at the connector and cycle the glass to ensure gear engagement. After the gears are engaged, Tighten the three motor and drive retaining screws to 5.6-9.8 N-m (50-84 lb-in).
3. Install two regulator mounting plate rivets.
4. Connect battery ground cable.
5. Check power window for proper operation.
6. Install door trim panel and watershield.

NOTE: Verify that all drain holes at bottom of doors are open to prevent water accumulation over motor.