Front

1. Remove air inlet tube, then remove stabilizer bar retaining bracket bolts and brackets.
2. Remove serpentine drive belt, then raise and support vehicle.
3. Remove front tire and wheel assemblies, then remove crankshaft vibration damper.
4. Remove cotter pins and castellated nuts at rod ends.
5. Separate tie rod ends from spindles using tie rod end removal tool No. 3290-D or equivalent.
6. Remove transmission oil cooler line bracket.
7. Remove stabilizer bar link from stabilizer bar using joint separator tool No. D88L-3006-A or equivalent.
8. Remove stabilizer bar from vehicles right side
9. Remove stabilizer bar bushings from stabilizer bar.
10. Reverse procedure to install. Tighten to specifications.