Headlamp Switch: Service and Repair

1. On models equipped with airbag, disarm airbag system as outlined under MAINTENANCE PROCEDURES/AIRBAG SYSTEM DISARMING.
2. On all models, disconnect battery ground cable.
3. Pull off headlamp switch knob and remove retaining nut.
4. Remove instrument cluster finish panel as follows:
a. Engage parking brake and remove ignition lock cylinder as described in Steps 5 thru 8.
b. On models with tilt column, set tilt column lever to full down position and remove tilt lever.
c. On all models, remove four bolts, then cover and reinforcement assembly from under steering column.
d. Remove steering column trim shrouds, then disconnect all electrical connections from steering column multi-function switch.
e. Remove two multi-function switch retaining screws, then the switch.
f. Pull gear shift lever to its lowest down position.
g. Remove four cluster opening finish panel retaining screws.
h. Pull finish panel away from instrument panel, then disconnect wiring from switches, clock and warning lamps.

Fig. 3 Ignition Lock Cylinder Removal:

5. Rotate ignition switch to the Run position, then working through steering column lower shroud, Fig. 3, depress lock cylinder retaining pin with suitable 1/8 inch drill.
6. Pull ignition lock cylinder from housing.
7. Remove two headlamp to instrument panel retaining screws.
8. Pull switch out of instrument panel, then disconnect electrical connector and remove switch.
9. Reverse procedure to install.
10. On models equipped with airbag, reactivate airbag system as outlined under MAINTENANCE PROCEDURES/AIRBAG SYSTEM DISARMING.