LH Kick Panel Safing Sensor

Removal

WARNING: THE ELECTRICAL CIRCUIT NECESSARY FOR SYSTEM DEPLOYMENT IS POWERED DIRECTLY FROM THE BATTERY. TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE BATTERY POSITIVE CABLE MUST BE DISCONNECTED PRIOR TO SERVICING OR REPLACING ANY SYSTEM COMPONENTS.

NOTE: To service stripped air bag sensor retaining screw center mounted sensor use screw (Part No. N802455-S190). Tighten to 13-17 N.m (10-12 lb-ft).

1. Disconnect battery positive cable.
2. Remove driver cowl side trim panel.






3. Disconnect LH safing sensor electrical connector.
4. Remove wiring locator on rail, and two screws retaining LH sensor to LH lower cowl side panel, and remove sensor from vehicle.

Installation
1. Position LH safing sensor to LH lower cowl side panel support, and secure with two retaining screws. Tighten screws to 6.8-9.2 N.m (61-81 lb-in).
2. Connect LH sensor electrical wiring connector to wiring assembly connector.
3. Install locator on connector into wiring retainer.
4. Connect positive battery ground cable.
5. Verify air bag indicator.