Power Mirror - Blows Fuse

9235ford02

Article No.
92-14-2

07/01/92


^ MIRROR - POWER - SWITCH BLOWS FUSE

^ SWITCH - POWER WINDOW - BLOWS FUSE


FORD:
1992 CROWN VICTORIA, TEMPO

LINCOLN-MERCURY:
1992 GRAND MARQUIS, TOPAZ


This TSB article is being republished in its entirety to update the technical information and parts involved when replacing the Power Mirror Control Switch.

ISSUE:
Adjusting the power mirror may cause the No. 4 circuit fuse (15 amp) to blow on some vehicles. This occurs because of an internal electrical short within the switch.

ACTION:
Inspect the power control switch. If the switch checks "good" and the switch part number is listed in the chart do not replace the switch. When the switch is defective or is NOT listed in the chart, replace the switch. Refer to the Service Manual, Section 01-09, for service details.


POWER MIRROR CONTROL SWITCH CHART

SWITCH PART
NUMBER VEHICLE LINE

F23Z-17B676-A Tempo/Topaz
F2AZ-17B676-A Crown Victoria/Grand
Marquis


NOTE:
AFTER THE NEW SWITCH IS INSTALLED, WRAP FOAM TAPE (E4AZ-19627-B, OR EQUIVALENT) AROUND THE CONNECTOR.

PART NUMBER PART NAME CLASS

F23Z-17B676-A Power Mirror Control Switch B
(Tempo/Topaz)
F2AZ-17B676-A Power Mirror Control Switch B
(Crown Victoria/Grand Marquis)
E4AZ-19627-B Foam Tape BM

OTHER APPLICABLE ARTICLES:
NONE
SUPERSEDES:
91-17-1
WARRANTY STATUS:
Eligible Under Bumper to Bumper
OPERATION DESCRIPTION TIME
921402A Replace Control Assembly - 0.5 Hr.
Crown Victoria, Grand
Marquis
921402A Replace Control Assembly - 0.4 Hr.
Tempo, Topaz
DEALER CODING
BASIC PART NO. CONDITION CODE
17B676 X1
OASIS CODES:
103000, 203000, 205000