Late Production

Removal

WARNING: THE ELECTRICAL CIRCUIT NECESSARY FOR SYSTEM DEPLOYMENT IS POWERED DIRECTLY FROM THE BATTERY. TO AVOID POSSIBLE PERSONAL INJURY, THE BATTERY POSITIVE CABLE MUST BE DISCONNECTED PRIOR TO SERVICING OR REPLACING ANY SYSTEM COMPONENTS.

1. Disconnect positive battery cable and wait one minute for backup power supply energy to be depleted.
2. Remove center console.
3. Remove sensor retaining screw and bolt.
4. Disconnect sensor lead from wiring harness connector.





5. Remove rear safing sensor.

Installation
1. Connect the sensor lead to the wiring harness connector.
2. Position the rear safing sensor and make sure the arrow faces to the front of the vehicle.
3. Install sensor retaining bolt and screw. Tighten screw to 3-4 N.m (27-35 lb-in). Tighten bolt to 23-31 N.m (17-23 lb-ft).
4. Install center console.
5. Connect positive battery cable.
6. Prove out air bag system.