Continental

1. Install memory saver, then disconnect battery negative cable.

2. Remove headlamp switch knob.





3. Remove right and left instrument panel moldings. Refer to Figure 1.

4. Set parking brake.

5. Position gearshift selector in First gear position.

6. Remove instrument panel cluster opening finish panel. See Figure 1.

7. Remove and discard headlamp switch.

8. Inspect headlamp switch electrical connector for heat damage. If the electrical connector exhibits obvious heat damage, it must be replaced. Obtain harness kit part # F80Z-11654-AA and install harness connector according to the instructions in this attachment. If the electrical connector does not exhibit obvious heat damage, proceed to next step.

NOTE:
Perform the following step only if the headlamp switch electrical connector is not damaged.





9. Remove terminal B3 from the headlamp switch electrical connector.See Figure 2. Cut terminal end off wire 13 mm (1/2 inch) from connector.Splice on new wire with correct terminal end obtained from switch + B3 kit, F8OZ-1 1654-BA. Install terminal into B3 terminal slot of connector.

10. Connect new headlamp switch to its electrical connector, then install headlamp switch to panel.

11. Install instrument panel cluster opening finish panel.

12. Position gearshift selector in Park position and release parking brake.

13. Install right and left instrument panel moldings.

14. Install headlamp switch knob.

15. Connect battery negative cable, then remove memory saver.

16. Check operation of headlamp switch.