Rear Door Glass

In-and-Out

1. Remove rear door trim panel and watershield. Doors
2. Loosen two screws retaining rear door window stabilizer.
3. Position front door window glass in or out as required.
4. Tighten rear door window stabilizer retaining screws.
5. Install rear door trim panel and watershield.

Fore-and-Aft

1. Remove rear door trim panel and watershield. Doors
2. Loosen rear door glass front run and bracket retaining screw and washer assembly.
3. Loosen lower nut and washer assembly retaining rear door glass front run and bracket and rear door glass channel front bracket to inner rear door panel.
4. Adjust rear door window glass fore-or-aft as required.
5. Tighten lower nut and washer assembly.
6. Tighten screw and washer assembly.
7. Install rear door trim panel and watershield.

Window Opening

1. Remove rear door trim panel and watershield. Doors
2. Lower rear door window glass approximately 50 mm (2 inches) from full up position.
3. With three retention points loosely installed, set the rear door window glass forward into B-pillar. Tighten rear door glass front run and bracket nut and washer No.1 and then 2 and 3.
4. Install rear door trim panel and watershield.