A7 - A8

A7 Actuator (Electrical) Check
- Turn ignition switch to OFF.
- Disconnect VAPS harness connector from module.






- Connect DVOM to Circuits 495 and 496.
- Measure resistance.
- Connect DVOM to Circuits 497 and 498.
- Measure resistance.
Is the resistance between 43 and 70 Ohms
Yes
Go to A8.
Is the resistance less than 43 or greater than 70 Ohms
Yes
Go to A10. A10 - A11

A8 Harness Voltage At Actuator Connector
- Turn ignition switch to OFF.
- Verify that VAPS connector is connected to VAPS module.
- Disconnect actuator connector from VAPS harness connector.
- Turn ignition switch to RUN.
- Wait five seconds.






- Measure DC voltage between Circuit 495 and ground.
Then measure voltage between Circuit 496 and ground.
- One of these two circuits should be greater than 10 volts and the other less than 2 volts.
- Repeat the two steps above for Circuit 497 and 498.
Do voltage readings check OK?
Yes
Go to A9. A9
No
REPLACE VAPS module. Service and Repair
Go to A2. A1 - A3