Rear - With Disc Brakes
Removal1. Raise vehicle on hoist.
2. Remove wheel and tire assembly.
3. Remove caliper assembly from brake adapter. Support caliper assembly with a length of wire. Brake Caliper
4. Remove push on nuts that retain rotor to hub and remove rotor.
5. Remove grease cap from bearing and hub assembly and discard grease cap.
6. Remove bearing and hub assembly retaining nut and discard.
7. Remove bearing and hub assembly from spindle.
ABS Disc Brakes - Sedan:
Index - Sedan:
ABS Disc Brakes - Wagon:
Index - Wagon:
Installation
1. Position bearing and hub assembly on spindle.
2. Install new hub retaining nut. Tighten to 255-345 N-m (188-254 lb-ft).
3. Install a new grease cap using Coil Remover T89P-19623-FH or equivalent. Tap on tool until grease cap is fully seated.
4. Install rotor assembly on hub. Install two push-on nuts that retain rotor.
5. Install caliper assembly to brake adapter.
6. Install wheel and tire assembly.
7. Lower vehicle.