Rear Door Window Regulator: Service and Repair

Removal

Window Regulator, Rear:

1. Remove rear door trim panel and watershield. Doors
2. Remove rear door window glass as outlined.
3. Remove three rivets (manual windows) attaching regulator mounting plate assembly to rear door inner panel.
4. Slide regulator arm plastic guides out of rear door glass channel front bracket C-channel.

NOTE: Use access hole in rear door inner panel for removal and installation.

5. Remove rear door window regulator from rear door.

Installation

1. Install rear door window regulator through the access hole in the rear door. Slide regulator arm plastic guides into rear door glass channel from bracket C-channel.
2. Install rivets using Heavy Duty Riveter D80L-23200-A or equivalent, or 1/4-20 x 1/2-inch screw and washer assemblies and 1/4-20 nut and washer assemblies to secure regulator mounting plate to door inner panel. Equivalent metric retainers may be used.
3. Cycle rear door window glass to check for smooth operation.
4. Install watershield and rear door trim panel.