Child Restraint Locking Clip Installation

Use the following procedure to install the locking clip:

1. Thread the safety belt webbing through the child safety seat according to the child seat manufacturer's instructions.
2. Buckle safety belt.





3. Pull on shoulder portion of the safety belt to make the lap portion fit snugly. Keeping lap safety belt snug, hold lap and shoulder belt portions of webbing together next to slip tongue and unbuckle safety belt.





4. Slide either corner of child safety belt locking clip slot that is closest to the tongue over both layers of belt webbing.





5. Pinch both opposite edges of belt webbing together and insert into child safety belt locking clip slot.





6. Pinch both layers of webbing together and insert into other slot of child safety belt locking clip in same manner as Step 5





7. Re-buckle safety belt. Forcibly tilt the child safety seat from side to side and also tug it forward to see if it is held securely in place. If excessive movement occurs, repeat Steps 2 through 7 or properly install child safety seat in a different seating position in the vehicle.