Ball Stud Throttle Linkage

^ Disconnect the cable from the ball stud at the throttle body.

^ Ensure the disconnected end of the cable does not come in contact with any of the surrounding parts.

^ From inside the vehicle, pull the cable core wire through its full travel.

- Does it feel rough, sticky or restricted?

^ Release the core wire.

- Does it stick or hesitate before returning to its original position?

^ Compress the spring at the throttle body end of the cable and observe the cable as it returns to its original position.

^ Does the spring stick or fail to return to its original position at a rapid rate?

YES -- If Yes to any of the questions: Replace the cable.

NO -- If No to all of the questions: Cable is functioning properly. Refer to the Throttle Body / Testing and Inspection / Procedures or adjust the carpet, floor mat, etc., as required.