Rear - With Disc Brakes
Removal1. Raise vehicle on hoist.
2. Remove wheel and tire assembly.
3. Remove rear disc brake caliper from brake adapter. Support rear disc brake caliper with a length of wire. Brake Caliper
4. Remove push on nuts that retain rear disc brake rotor to wheel hub and remove rear disc brake rotor.
5. Remove rear hub cap grease seal from bearing and rear hub and discard rear hub cap grease seal.
6. Remove rear axle wheel hub retainer and discard.
7. Remove wheel hub from rear wheel spindle.
ABS Disc Brakes - Sedan:
Index - Sedan:
ABS Disc Brakes - Wagon:
Index - Wagon:
Installation
1. Position wheel hub on rear wheel spindle.
2. Install new rear axle wheel hub retainer.
Tighten to 255-345 NM (188-254 ft-lbs).
3. Install a new rear hub cap grease seal using Coil Remover T89P-19623-FH or equivalent. Tap on tool until rear hub cap grease seal is fully seated.
4. Install rear disc brake rotor on hub.
Install two push-on nuts that retain rear disc brake rotor.
5. Install rear disc brake caliper to brake adapter.
6. Install wheel and tire assembly.
7. Lower vehicle.