Air Bag Warnings and Safety Instructions
WARNINGS:
- Never probe the connectors on the air bag. Doing so may result in air bag deployment which could result in personal injury.
- Air bag modules with discolored or damaged cover deployment doors must be replaced, not repainted.
- Because of the critical operating requirements of the system, do not attempt to service sensors, air bag sliding contact, air bag diagnostic monitor, backup power supply or air bag module. Service is made by replacement only.
- If a part is replaced and the new part does not correct the condition, install the original part and perform the diagnostic procedure again.
- All component replacements and wiring service must be made with the battery ground cable disconnected for a minimum of one minute before service or replacement is attempted. Failure to do so could result in system deployment and personal injury.
- The instruction to "disconnect" always refers to the connector. never detach a component from the vehicle when instructed to "disconnect."
- Vehicle sensor orientation is critical for proper system operation. If a vehicle equipped with an air bag system has been involved in a crash where the fenders or grille area have been damaged, inspect the sensor mounting brackets for deformation. If damaged, the sensor should be replaced whether or not the air bag is deployed. In addition, ensure that the body structure in the area of the sensor mounting is restored to its original condition.