Ignition Coil

REMOVAL
1. Disconnect engine control sensor wiring connector from ignition coil. Disconnect engine control wiring connector from radio ignition interference capacitor.
2. Disconnect ignition coil wire from ignition coil.

Ignition Coil Assembly:

3. Remove ignition coil retaining screws, ignition coil, and radio ignition interference capacitor (if required) from ignition coil mounting bracket.
4. Remove ignition coil cover from ignition coil by releasing locking tabs on both sides of ignition coil cover.

INSTALLATION
1. To install, reverse Removal procedure.
2. Tighten ignition coil retaining screws to 2.8-4.0 Nm (25-35 in lb).