Front Belt Assembly

NOTE: Seat Belt Bolt Bit T77L-2100-A (No. 50 TORX) should be used for safety belt bolt removal and installation on front outboard safety belts.

REMOVAL
1. Remove front seat shoulder strap guide cover.
2. Insert Seat Belt Bolt Bit T77L-2100-A (No. 50 TORX) and remove safety belt bolt.
3. Remove B-pillar center body pillar inside lower finish panel.
4. Remove front door scuff plate retaining screws and center body pillar inside lower finish panel.
5. Remove safety belt anchor bolt and slide safety belt through slot in center body pillar inside lower finish panel.
6. Remove safety belt anchor plate-to-sill bolt and rubber washer.
7. Remove safety belt retractor bolt.
8. Remove front safety belt guide retaining screw and slide front safety belt guide rearward to remove from B-pillar.
9. Remove outboard front safety belt retractor and tongue from vehicle.

INSTALLATION
1. To install, reverse removal procedure. Position safety belts as shown.
2. Make sure safety belt webbing is not twisted. If it is, remove the twist.
3. Install all safety belt anchor bolts. Tighten to 30-40 Nm (22-30 lb ft).
4. Check the restraint system for proper operation.