Rear - With Drum Brakes

Bearing and Hub Assembly, Drum Brakes

Removal
1. Raise vehicle on hoist.
2. Remove wheel and tire assembly.
3. Remove two pushnuts retaining brake drum to wheel hub and remove brake drum.
4. Remove rear hub cap grease seal from wheel hub assembly and discard rear hub cap grease seal.
5. Remove rear axle wheel hub retainer and discard.
6. Remove wheel hub from rear wheel spindle.

Drum Brakes - Hub And Bearing:

Installation
1. Position rear hub on rear wheel spindle.
2. Install new rear axle wheel hub retainer and tighten to 255-345 NM (188-254 ft-lbs).
3. Install new rear hub cap grease seal using Coil Remover T89P-19623-FH or equivalent.
Tap on tool until grease cap is fully seated.
4. Install brake drum on rear hub.
Install two pushnuts that retain drum.
5. Install wheel and tire assembly.
6. Lower vehicle.