Ignition Coil Pack

Removing Ignition Wires At Coil Pack:

REMOVAL

1. Disconnect fuel charging wiring connectors from ignition coil and radio ignition interference capacitor.
2. Disconnect ignition wires by squeezing locking tabs and twisting while pulling upward.
3. Remove four ignition coil retaining screws and remove ignition coil and radio ignition interference capacitor. Save radio ignition interference capacitor for installation with ignition coil.

INSTALLATION

1. Position ignition coil and radio ignition interference capacitor to ignition coil bracket.
2. Install retaining screws and tighten to 5-7 Nm (44-61 lb in).
3. Apply Silicone Dielectric Compound D7AZ-19A331-A (Motorcraft WA-10) or equivalent meeting Ford specification ESE-M1C171-A to all ignition wire boots.
4. Install each ignition wire connector to the proper terminal on the ignition coil. Make sure boots are fully seated.
5. Connect engine control sensor wiring to the ignition coil and radio ignition interference capacitor.