Rear - With Drum Brakes

Drum Brakes

Removal
1. Raise vehicle on hoist.
2. Remove wheel and tire assembly.
3. Remove two push-on-nuts retaining brake drum (1126) to wheel hub and remove brake drum.
4. Remove rear hub cap grease seal from wheel hub assembly and discard rear hub cap grease seal.
5. Remove rear axle wheel hub retainer and discard.
6. Remove wheel hub from rear wheel spindle.

Drum Brakes - Hub And Bearing:

Installation
1. Position wheel hub on rear wheel spindle.
2. Install new rear axle wheel hub retainer and tighten to 255-345 NM (188-254 ft-lbs).
3. Install new rear hub cap grease seal using Shaft Protector for Coil Removal T89P-19623-FH. Tap on tool until rear hub cap grease seal is fully seated.
4. Install brake drum on wheel hub. Install two push-on-nuts that retain brake drum.
5. Install wheel and tire assembly.
6. Lower vehicle.