Front Control Unit
SPECIAL SERVICE TOOL(S) REQUIREDDescription Tool Number
Radio Removing Tool TS7P- 19061-A
REMOVAL
1. Disconnect battery ground cable.
2. Install Radio Removing Tool T87P-19061-A into radio face plate. Push tool in approximately 38 mm (1.5 inches) to release retaining clips.
CAUTION: Do not use excessive force when installing radio removal tool, as this will damage retaining clips and may make radio chassis removal difficult or cause damage to the radio chassis.
3. Apply a slight spreading force on tool and pull radio chassis out of instrument panel.
4. Disconnect the wiring connectors and remove the radio chassis.
INSTALLATION
1. Connect wiring connectors to radio chassis.
2. Slide radio chassis into instrument panel, making sure radio chassis is squarely inserted.
3. Push radio chassis inward until retaining clips are fully engaged.
4. Connect battery ground cable.