Message Center Switch Module

REMOVAL
1. Disconnect battery ground cable.
2. Set parking brake.
3. Unsnap LH instrument panel moulding and RH instrument panel moulding and remove from instrument panel finish panel.
4. Pull center panel switches (if equipped) forward, disconnect electrical connectors and remove the center switches.
5. Remove instrument panel steering column cover.
6. Remove four nuts retaining the steering column and lower the steering column.
7. Remove knob from headlamp switch.
8. Remove 13 screws retaining instrument panel finish panel and pull instrument panel finish panel out.
9. Move gearshift lever to low gear (1) position if required for easier access.
10. Disconnect electrical connecters from message center switch module.
11. Remove two screws on either side of message center switch module.
12. Remove message center switch module from rear of the instrument panel finish panel and replace.

INSTALLATION
1. Follow removal procedure in reverse order.