Installation

1. Align the steering column lower yoke to lower steering column shaft. Install one bolt and tighten to 25-35 Nm (19-25 ft. lbs.).
2. Connect parking brake release switch vacuum hoses.
3. Support the steering column to steering column support bracket. Install four retaining nuts and tighten to 13-19 Nm (115-168 inch lbs.).
4. Position shift cable and bracket to lower two screws of steering actuator housing. Tighten to 7-11 Nm (62-97 inch lbs.).
5. Snap shift cable and bracket onto shift selector pivot ball.
6. Position multi-function switch and install two retaining screws. Tighten to 2-3 Nm (18-26 inch lbs.).
7. Connect all electrical connectors.
8. Install transmission shift cable and bracket loop on shift selector hook, and install transmission range selector cable bracket to steering actuator housing. Install retaining screw.
9. Install instrument panel reinforcement brace and secure with two retaining bolts.
10. Install lower instrument panel cover.
11. Snap RH and LH lower instrument panel mouldings into place.
12. Install upper steering column shroud and lower steering column shroud.
13. Install ignition switch lock cylinder assembly.
14. Install tilt wheel handle and shank onto steering column lock cylinder housing.
15. Install air bag sliding contact screw. Tighten to 2-3 Nm (18-26 inch lbs.).
16. Install steering wheel onto steering column shaft assembly. Install a new bolt and tighten to 34-46 Nm (26-33 ft. lbs.).
17. Position driver side air bag module to steering wheel. Install four retaining nuts. Tighten to 4-6 Nm (36-53 inch lbs.).
18. Connect battery ground cable and air bag backup power supply.