Manual

REMOVAL
1. Remove seat and track assembly.







2. Remove spring clip and front seat back adjusting handle from front seat back latch.
3. Disengage J-retainer and arrow retainers at outboard right rear corner and J-retainer from cushion frame side. Pull back trim cover.
4. Remove push pin retainers and remove trim cover from manual front seat back latch. Disconnect front seat back pad adjusting tube (if equipped).







5. Remove two screws retaining manual front seat back latch and pivot bolt on inboard side. Remove front seat back assembly.
6. Disengage J-retainers at bottom of front seat back and pull up seat back liner.







7. Remove front seat back head restraint.
8. Unscrew front seat head rest guide rod retainers from front seat head rest guide rod sleeves.
9. Release hand rest guide rod springs.
10. Peel front seat back cover from bottom to top while disengaging hook fastener tiedowns.

INSTALLATION
1. Follow removal procedure in reverse order.
2. Tighten manual front seat back latch retaining screws to 23-32 Nm (17-23 Lb-Ft).