Power

REMOVAL
1. Disengage J-retainer and arrow retainers at outboard RH rear corner and J-retainer from cushion frame side. Pull back trim cover.

NOTE: The power seat back adjuster is a modular design and components cannot be serviced or replaced individually. The entire power seat back adjuster assembly must be replaced if any component is non-functional or damaged.

2. Remove push pin retainers and remove trim cover from power seat back adjuster.
3. Disconnect front seat back pad adjusting tube (if equipped) and disconnect harness connector.
4. Remove two screws retaining power seat back adjuster to front cushion frame (on outboard side) and pivot bolt on inboard side. Remove front seat back assembly.
5. Disengage J-retainers at bottom of front seat back assembly and pull up front seat back cover.
6. Remove two screws retaining power seat back adjuster to front seat back frame and remove power seat back adjuster.

INSTALLATION
1. Follow removal procedure in reverse order.
2. Tighten power seat back adjuster retaining screws to 23-32 Nm (17-23 Lb-Ft).