Rear

REMOVAL
1. Raise vehicle on hoist and place jackstands under the frame side rails.
2. Lower the hoist and rear axle assembly housing until the shock absorbers are fully extended.
3. Disconnect rear stabilizer bars from rear stabilizer bar link and bushing. Remove bolts and stabilizer bar bracket retaining rear stabilizer bar to rear axle assembly.

INSTALLATION
1. Install two stabilizer bar brackets onto lower suspension arm stabilizer bar insulators and hook both brackets into T-slot of rear axle bracket. Install two retaining bolts and tighten to 21-29 Nm (16-21 ft. lbs.).
2. Connect rear stabilizer bar eyes to rear stabilizer bar link and bushings using lower suspension arm stabilizer bar insulators and nut and washer assembly. Tighten to 17-23 Nm (13-16 ft. lbs.).
3. Lower vehicle.