Post-Service Procedures

After the service is complete and the fuel charging system is installed to engine, perform the following steps:
1. Install fuel tank filler cap at fuel tank.
2. Connect battery ground cable.

NOTE: When the battery has been disconnected and reconnected, some abnormal drive symptoms may occur while the Powertrain Control Module (PCM) relearns its adaptive strategy. The vehicle may need to be driven 10 miles or more to relearn the strategy.

3. Add engine coolant if required.

WARNING: The fuel system is normally pressurized to 276 kPa (40 psi). Use care when servicing the fuel system or personal injury may occur.

4. Turn ignition switch ON/OFF several times without starting engine to pressurize system. Check for fuel leaks.

NOTE: Check all connections at fuel injection supply manifold, fuel injectors, fuel line push connect fittings, etc.

5. Start engine and warm to operating temperature. Check for engine coolant leaks if coolant was removed.
6. Perform Powertrain Control Module On-Board Diagnostics. Refer to Computers and Control Systems / Testing and Inspection.