Starting System: Description and Operation
STARTER SYSTEMThe starting system cranks the engine at a speed fast enough to permit the engine to start.
^ Heavy duty cables, connectors and switches are used because of the large current required by the starter motor while it cranks the engine.
^ The amount of resistance in the starting circuit must be kept to a minimum to provide maximum current for starter motor operation.
^ A discharged or damaged battery, loose or corroded connections or partially broken cables will cause slower than normal cranking speeds and may prevent the starter motor from cranking the engine.
^ In case of starting system difficulty, the operator may have discharged the battery before calling for assistance.
^ A road service procedure is to aid the service technician in such cases of a discharged battery.
The starting system includes the following:
^ Permanent magnet gear-reduction starter motor with a solenoid-actuated drive.
^ Remote control starter switch (part of the ignition switch).
^ The Transmission Range (TR) sensor.
^ Starter solenoid.
^ Heavy circuit wiring.
Vehicles equipped with an automatic transaxle have a Transmission Range (TR) sensor in the starter control circuit, which prevents operation of the starter motor unless the transaxle range selector lever is in the NEUTRAL or PARK position.
Sequence of Operation
When the ignition switch is turned to the START position:
^ Voltage is provided to the starter solenoid. The starter solenoid is energized directly from the ignition circuitry. A magnetic field is created in the solenoid coil.
^ The iron plunger core is drawn into the solenoid coil.
^ A lever connected to the starter drive engages the drive pinion gear to the flywheel ring gear or off set driven gear (depending upon application).
^ When the iron plunger core is all the way into the coil, its contact disc closes the circuit between the battery and the starter motor terminals.
^ The current flows to the motor, and the starter drive cranks the flywheel and the engine crankshaft.
^ As current flows to the motor, the solenoid pull-in coil is bypassed.
^ The hold-in coil keeps the starter drive engaged with the flywheel.
^ The starter drive remains engaged until the ignition switch is released from the START position.
An overrunning clutch in the starter drive protects the starter motor from excessive speeds during the brief period before the driver releases the ignition switch from the START position (as the engine starts).