Rear

REMOVAL
1. Raise and support the vehicle.
2. Remove the rear wheel and tire assemblies.





3. Position a (A) floor jack stand under the (B) rear floor cross member.





4. Remove the rear stabilizer bar link.
a. Remove the rear stabilizer bar end nut (1).
b. Remove the rear stabilizer bar end bolt (2).
c. Remove the retainer (3).
d. Remove the two upper rear stabilizer bar end bushings (4).
e. Remove the rear stabilizer bar end retainer spacer (5).
f. Remove the two lower rear stabilizer bar end bushings (6).
g. Remove the retainer (7).





5. Remove the four rear floor cross member nuts and lower the rear floor cross member.





6. Remove the rear suspension arm and bushing (front) nut.





7. Remove the rear suspension arm and bushing (front) bolt and remove the rear suspension arm and bushing.











INSTALLATION
To install, reverse the removal procedure noting the following:

NOTE: Check the rear alignment and adjust as necessary.