Front

REMOVAL
1. Support the engine with a Three-Bar Engine Support D88L-6000-A.
2. Raise and support the vehicle.





3. Remove the (A) lug nuts and the (B) wheel and tire assembly.





4. Remove the (A) bolts and the (B) crossmember.





5. Remove the four nuts securing the steering gear mounting brackets.





6. Position the steering gear slightly forward.





7. Remove the front stabilizer bar link nuts, retainers, bushings, bolts and sleeves.





8. Remove the (A) transaxle insulator nuts and the (B) two rear engine support to vehicle frame nuts.





9. Lower the end of the transaxle support crossmember.





10. Remove the front sub-frame to vehicle frame nuts.

NOTE: The engine and transaxle mounts will support the front sub-frame when unbolting the front sub-frame from the vehicle frame.





11. Remove the bolts (rear) securing the front sub-frame to the vehicle frame and lower the front sub-frame.





12. Remove the front stabilizer bar bolts from the front sub-frame and remove front stabilizer bar.














INSTALLATION
1. To install, reverse the removal procedure noting the following:





2. Tighten the front stabilizer bar link nuts so that 17-19 mm (0.67-0.75 inch) of thread is exposed.