Front

1. Grease or any other foreign material must be kept off lining surfaces and braking surfaces of front disc brake rotor and external surfaces of wheel hub during service operation.
2. When handling front disc brake rotor and disc brake caliper assemblies, avoid deformation, nicking or scratching of brake pads and linings and front disc brake rotor.
3. If a caliper piston is removed for any reason, both piston seals and dust boots must be replaced.
4. During removal and installation of a wheel assembly, exercise care not to interfere with or damage front disc brake rotor shield or the bleeder screw.
5. Do not attempt to clean or restore any oil or grease soaked brake pads and linings. When contaminated, brake pads and linings must be replaced in complete axle sets and front disc brake rotor braking surfaces wiped clean.
6. The LH and RH disc brake calipers must be installed on the correct side of the vehicle to be sure bleeder screw is in the topmost position for proper purging of air from the front brake system during bleeding.