A/C Discharge Hose/Line
SPECIAL SERVICE TOOL(S) REQUIREDDescription Tool Number
Spring Lock coupling Disconnect Tool (5/8 inch) 412-038 (T83P-19623-C)
REMOVAL
1. Discharge the refrigerant from the A/C system following the recommended procedure and observing all safety precautions. Discharging and Recovery
2. Remove A/C pressure cut-off switch.
3. Loosen nut retaining A/C compressor to condenser discharge line to stud on engine front cover.
4. Disconnect and remove the A/C compressor to condenser discharge line using Spring Lock Coupling Disconnect Tool 412-038 (T83P-19623-C).
INSTALLATION
1. With the protective caps installed, route the new refrigerant line.
2. Remove protective caps then connect the A/C compressor to condenser discharge line into the system using new O-ring seals lubricated with clean Motorcraft YN-12c refrigerant oil or equivalent meeting Ford specification WSH-M1C231-B. Tighten peanut fitting retaining nut to 7-9 N.m (62-79 lb-in).
3. Install nut retaining A/C compressor to condenser discharge line to stud on engine front cover. Tighten to 17-23 N.m (13-16 lb-in).
4. Install the A/C pressure cut-off switch.
5. Leak-test, evacuate and charge the refrigerant system following the recommended procedure and safety precautions.
6. Check the A/C system for proper operation.