Keyless Entry: Service and Repair

NOTE:
- A maximum of four key less entry remote transmitters can be programmed for each central locking/anti-theft module. Programming must be done at the same time for all the transmitters.
- To enter programming mode, first verify that the battery is fully charged and the anti-theft system is not armed or triggered (if equipped).

1. Turn the ignition switch from OFF to ON five times within ten seconds, ending in the ON position.
2. Press any button on the keyless entry remote transmitter.

NOTE: If the central locking/anti-theft module successfully enters program mode, it will LOCK then UNLOCK all doors.

3. To program additional keyless entry remote transmitters, repeat step 2.

NOTE: The door locks will LOCK then UNLOCK to acknowledge that the keyless entry remote transmitter has successfully been programmed.

4. When finished programming all transmitters, turn the ignition switch OFF.

NOTE: The door locks will LOCK then UNLOCK one last time to indicate the new transmitters have been programmed, and program mode is now exited.