Sliding Roof Height Adjustment

1. Position the sliding roof panel surround.
1 Remove the retaining screws.
2 Position the surround above the headliner space.







2. Adjust the rear edge of the sliding roof glass panel.
1 Loosen the center and rear screws on both sides.
2 Push the rear edge UP/DOWN to the correct alignment (flush to + 1 mm).







3. Adjust the front edge of the sliding roof glass panel.
1 Loosen the center and front screws both side.
2 Push the front edge UP/DOWN to give correct alignment (flush to - 1 mm).







4. Tighten the retaining screws.







5. Check roof seal for wind noise and water leaks.