Crankshaft

GENERAL SPECIFICATIONS
Main Bearing Journal Dia. 57.980-58.000 mm
Main Bearing Journal End Float 0.09-0.26 mm
Big-End Bearing Journal Dia. 46.89-46.91 mm
Required Shim Thickness Where There Is A Gap Between The Cylinder Block And The Lower Crankshaft:
0.26 mm to 0.50 mm 0.25 mm
0.51 mm to 0.75 mm 0.50 mm
Out Of Round Limit 0.008 mm
Taper Limit 0.008 mm per 25.4 mm
Journal Runout Limit 0.05 mm
Runout of Bearings 2, 3, and 4 Crankshaft End Play 0.100-0.300 mm
Surface Finish (RMS) micro 0.3 mm
Clearance to Crankshaft 0.020-0.065 mm
Thrust Bearing Journal Length 28.825-28.854 mm
Connecting Rod Journal Diameter 43.89-43.91 mm
Surface Limit (RMS)
Rear 0.6 Micro mm
Front 0.9 Micro mm
Main Bearing Thrust Face Surface finish (RMS) 0.6 Micro mm
Rear 0.9 Micro mm
Front Runout Limit (T.I.R.) 0.025 mm
Flywheel Clutch Face Runout Limit (T.I.R.) 0.180 mm
Flywheel Ring Gear Lateral Runout (T.I.R.) Man. Trans. 0.64 mm
Flywheel Ring Gear Lateral Runout (T.I.R.) Auto. Trans 1.5 mm
Crankshaft End Play 0.100-0.300 mm