Switch - Lock Cylinder Illumination

REMOVAL
1. Remove the door trim panel.







2. Remove the door watershield.
^ Using a plastic knife, cut through the Butyl strips to enable the watershield to be peeled back.

CAUTION: Do not touch the adhesive surface as re-bonding will be impaired. Do not attempt to peel the watershield from the door without cutting the Butyl strip.







3. Release the tang and remove the switch before removing from the bracket.

CAUTION: Do not move switch past the vertical, as damage may result.







4. Remove the wiring harness from its retainers.







5. Remove the lock cylinder illumination switch.
1 Unclip the switch wiring.
2 Disconnect the electrical connector.

INSTALLATION
1. To install, reverse the removal procedure.