Pressure Bleeding

CAUTION:
- Make sure that the vehicle is standing on a level surface or supported on a non-wheel free hoist.
- If brake fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.

NOTE: The system consists of separate circuits for each front and diagonally opposite rear wheel. Each front to rear circuit and each wheel circuit can be bled individually of each other.

1. Disconnect the battery ground cable.





2. Remove the reservoir filler cap.

1 Disconnect the low fluid level warning light switch electrical connector.
2 Remove the cap.

CAUTION: Make sure that the filler cap does not become contaminated.





3. Fill up the fluid reservoir to the MAX mark.
4. Pressure bleed the system using a 104-00064 pressure bleeder or equivalent and the equipment manufacturers instructions.

CAUTION: The manufacturers instructions must be strictly adhered to.





5. Fill up the fluid reservoir to the MAX mark.
6. Install the components in reverse order.