Sliding Roof Height Adjustment

The correct position of the roof sliding outer glass panel to the roof panel is as follows:
^ front corners: flush to 1 mm (0.039 inch) below roof panel.
^ rear corners: flush to 1 mm (0.039 inch) above roof panel.
1. Cycle roof sliding outer glass panel from full open to full closed position.
2. Remove three roof sliding panel opening shield retaining screws along front of the opening inside of vehicle and slide roof sliding panel opening shield and roof sliding panel headlining fully rearward to expose six roof sliding outer glass panel retaining screws (three on each side).
3. Loosen six roof sliding outer glass panel retaining screws. Tighten them so that they are snug but not tightened to specification.
4. To adjust the front of roof sliding outer glass panel, loosen the center and front screws. To adjust only the back of the roof sliding outer glass panel, loosen the center and rear screws.
5. To check height setting, open the roof sliding outer glass panel about 101 mm (4 inches) then return to the closed position.
6. Slide roof sliding panel opening shield forward and replace three retaining screws.
7. Tighten the roof sliding outer glass panel retaining screws to 0.8-1.5 N.m (7-13 Lb-In).
8. Close roof sliding panel headlining if desired.