Sliding Roof Headlining

REMOVAL
1. Remove roof sliding outer glass panel.
2. Slide roof sliding panel opening shield and roof sliding panel headlining forward halfway across roof sliding panel opening shield opening.







3. Lift roof sliding panel opening shield to clear roof sliding panel headlining.
4. Push roof sliding panel opening shield fully rearward.
5. Slide roof sliding panel headlining fully forward.







6. Lift front on roof sliding panel headlining, slide forward and rotate 90 degrees to remove.

INSTALLATION
1. With roof sliding panel headlining at an angle, insert one roof sliding panel headlining rear tab into channel at rear of roof panel opening.
2. Insert other rear tab and place roof sliding panel headlining in position.
3. Slide roof sliding panel opening shield forward, lifting it to clear roof sliding panel headlining.
4. Lower roof sliding panel opening shield onto roof sliding panel headlining. Roof sliding panel opening shield must be outside of rail or roof panel will not function properly.
5. Slide roof sliding panel headlining and roof sliding panel opening shield fully rearward.
6. Install roof sliding outer glass panel.
7. Adjust roof sliding outer glass panel.
8. Slide roof sliding panel opening shield fully forward, locate over glass panel flange and push upward to snap into position.
9. Close roof sliding panel headlining if desired.