Link

REMOVAL
1. Remove rear stabilizer bar.
2. Slide rear stabilizer bar link and bushing assemblies off of rear stabilizer bar.

INSTALLATION
1. Clean rear stabilizer bar of dirt and other contamination.

NOTE: If the rear stabilizer bar to body link assemblies are being reused, clean the link lower insulator inside diameter with a bottle brush to remove any dirt or paint build-up. Lube the insulator prior to reassembly. Use only Rubber Suspension Insulator Lube E25Y-19553-A or equivalent meeting Ford specification ESF-M99B112-A.

2. Lubricate rear stabilizer bar from the end of the bar to the lower suspension arm stabilizer bar insulator contact area with Rubber Suspension Insulator Lube E25Y-19553-A or equivalent meeting Ford specification ESF-M99B112-A and slide on two rear stabilizer bar link and bushings to approximate position.
3. Install rear stabilizer bar.