Fore-and-Aft Adjustment

1. Fore-and-aft adjustment of the roof sliding outer glass panel can be accomplished by first estimating the amount of fore or aft adjustment necessary for proper roof sliding outer glass panel fit. Then run roof sliding outer glass panel fully rearward.
2. Operate sliding roof sliding outer glass panel to the full-open position.







3. Loosen 3 screws retaining the adjustable roof sliding panel rails.












4. Locate and use the series of calibration marks at the front of each roof sliding panel rail. Adjust roof sliding outer glass panel fore or aft as required, making sure both roof sliding panel rails are uniform to calibration marks.
5. Check clearance between seal and roof sliding outer glass panel with a 0.25 mm feeler gauge.
6. Tighten all retaining screws to 4-6 Nm (36-53 lb-in).

CAUTION: Hand-tighten all screws. DO NOT use air tools or damage to holes in roof sliding panel housing may occur.