Pressure Hose

Special Tools:

Removal
1. Open hood.
2. Disconnect battery ground cable.
3. Drain and remove radiator coolant recovery reservoir.
4. Drain and remove power steering pump reservoir.
5. Remove drive belt.
6. Using Steering Pump Pulley Remover 211-016 (T69L-10300-B), remove power steering pump pulley from power steering pump described.
7. Disconnect pressure line mounting bracket from engine assembly.
8. Disconnect power steering pressure hose from power steering pump fitting.
9. Disconnect electrical connector from PSP switch.
10. Disconnect pressure line mounting bracket at top of steering shaft U-joint shield.
11. Disconnect power steering pressure hose from power steering rack fitting and remove power steering pressure hose from vehicle.

Installation
1. Follow removal procedure in reverse order.
2. Use Steering Pump Pulley Replacer 211-009 (T65P-3A733-C) to install power steering pump pulley.
3. Using Teflon Seal Replacer 211-D027 (D9OP-3517-A), install new seals on power steering pressure hose.
4. Fill and bleed power steering system with Motorcraft MERCON(r) Multi-Purpose ATF XT-2-QDX or MERCON(r) equivalent. Check system for leaks and proper operation.