Oil Pump: Service and Repair

Removal
1. Remove the timing belt.
2. Raise and support the vehicle.
3. Remove the oil pan.





4. Disconnect the Crankshaft position (CKP) sensor electrical connector.





5. Remove the two bolts and the oil pump screen cover and tube. Discard the gasket.





6. Remove the six bolts, the oil pump and the oil pump to cylinder block gasket. Discard the gasket.

Installation

1. CAUTION: Do not use abrasive grinding discs to remove gasket material; use only plastic manual scrapers. Do not scratch or gouge aluminum sealing surfaces.

Clean and inspect the mounting faces of both the oil pump and the cylinder block. Both surfaces must be clean and flat.








2. Note: Lubricate the crankshaft front oil seal lip with Super Premium 5W30 SAE Motor Oil X0-5W30-QSP or equivalent meeting Ford specification WSS-M2C153-G.

Note: When the oil pan bolts are tightened, the oil pump to cylinder block gasket must be below the cylinder block sealing surface.

To install, reverse the removal procedure.