Fluid - A/T: Service and Repair

AX4N Transaxle
1. Place the transaxle range selector lever in the PARK position.
2. Set the parking brake.
3. Start the engine and check the transmission fluid level and condition.
4. Turn the engine off.





5. Remove the lower retaining clip from the lower transaxle cooler line fitting.





6. Depress the tabs on the plastic insert retainer and remove cooler line from fitting.





7. Attach a flexible hose, approximately 0.9 m (3.0 ft.) in length, to the fluid cooler tube with the other end in a suitable, 15-quart container.

8. Note: When plugging the cooler tube fitting make sure the plug is made of a soft material to prevent damage to the internal seal of the cooler tube fitting.





Insert a plug into the cooler tube fitting on the transaxle.
9. Lower the vehicle.

10. CAUTION: When the steady stream of transmission fluid stops flowing, the engine must be turned off to prevent damage to the transaxle. Engine rpm should not exceed curb idle speed while draining the transmission fluid.





Start the engine and run at idle while observing the flexible hose for 40-60 seconds until the steady stream of fluid stops flowing. Turn the engine off. This step will drain approximately 1.9 - 2.8 liters (2 - 3 quarts) of transmission fluid.

11. Fill the transaxle with 9.5 liters (10 quarts) of MERCON (R) V Automatic Transmission Fluid XT-5-QM or equivalent meeting MERCON V specification.

12. CAUTION: When the steady stream of transmission fluid stops flowing, the engine must be turned off to prevent damage to the transaxle. Engine rpm should not exceed curb idle speed while draining the transmission fluid.





Start the engine and run at idle while observing the flexible hose for 2-3 minutes until the steady stream of fluid stops flowing. Turn the engine off. This step will drain approximately 9.5 liters (10 quarts).
13. Raise and suitably support the vehicle.





14. Remove the plug from the cooler tube fitting.





15. Remove the flex hose from the cooler tube.

16. Note: Clean the cooler tube fitting before installing it to ensure a good connection and to prevent any leaks.





Install the lower cooler tube.
17. Lower the vehicle.
18. Fill the transaxle with 1.9 liters quarts) of MERCON (R) V Automatic Transmission Fluid XT-5-QM or equivalent meeting MERCON V specification..
19. Start the engine and move the transaxle range selector lever through all the ranges allowing the transaxle to engage in each position.
20. Check the transaxle at normal operating temperature. Fluid should be within the crosshatch area of the fluid level indicator. If the fluid is not within the crosshatched area add fluid in 0.2365-liter (1/2 pint) increments until the correct